Featured Project · State of Utah DFCM

Commercial HVAC Rough-In — DFCM Project, American Fork

A State of Utah DFCM-managed commercial construction project in American Fork, Utah. Honest Heating & Cooling installed the full HVAC rough-in: custom ductwork, air handler, and energy recovery ventilator (ERV).

DFCM State Project

Why a DFCM Project Matters

DFCM — the State of Utah Division of Facilities Construction & Management — oversees state construction projects with strict standards for bonded, insured, licensed subcontractors.

Being trusted with a DFCM-managed HVAC rough-in means our work meets state construction compliance, drawing coordination, and inspection standards. For GCs and property owners outside the state project world, that's the same quality bar we bring to private commercial work.

Spiral commercial ductwork with ceiling diffusers on a State of Utah DFCM project in American Fork by Honest Heating & Cooling

Rough-In Progress Photos

In-progress shots from our crew on-site. Project in active construction.

Commercial HVAC ductwork rough-in on a DFCM state project in American Fork, Utah

Ductwork Rough-In

Supply duct feeding into framed wall assembly, coordinated with structural steel and framing.

Commercial sheet metal ductwork rough-in during tenant improvement, American Fork DFCM project

Branch Ductwork & Framing Coordination

In-house fabricated sheet metal routed above metal stud framing. Clean runs, properly supported.

Spiral commercial duct with ceiling diffusers on DFCM American Fork HVAC project

Spiral Supply with Diffusers

Insulated spiral supply duct with branch takeoffs feeding ceiling diffusers for even air distribution.

Energy recovery ventilator (ERV) install on a commercial DFCM project in American Fork, Utah

ERV Install

Energy recovery ventilator mounted and piped — pulls fresh outside air while recovering heat/cool from exhaust air for efficiency.

Bryant commercial air handler installed by Honest Heating & Cooling on a Utah DFCM project

Bryant Air Handler

Bryant commercial air handler installed and connected — ready for ductwork tie-in and controls commissioning.

Project Scope

  • Location: American Fork, Utah
  • Managed by: State of Utah DFCM (Division of Facilities Construction & Management)
  • Scope: Full commercial HVAC rough-in
  • Equipment: Bryant air handler + ERV (energy recovery ventilator)
  • Ductwork: In-house custom sheet metal fabrication, spiral supply, insulated runs
  • Coordination: Framing, structural steel, ceiling grid, electrical
  • Status: Active construction — rough-in phase

Running a Commercial Project? Let's Talk.

We bid commercial HVAC for Utah GCs daily — tenant improvement, RTU work, new construction, state and private projects. Send us the plans, the address, or just give us a call.